How long does a water pump usually last?

How long does a water pump usually last? The average lifespan of a water pump is similar to the lifespan of a timing belt. They usually last 60,000 to 90,000 miles with the proper care. However, some cheaper water pumps may begin leaking at as low as 30,000 miles.

How often does a water pump need to be replaced? Facts and figures: a working water pump only needs to be replaced after 60,000-100,000 miles, so if you have your car for less than 10 years, you may never have to worry about it.

How expensive is it to replace a water pump? The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314. Estimate doesn’t include fees and taxes.

Do you need to replace thermostat when replacing water pump? Most of the time, RRT will recommend replacing the thermostat at the same time as the water pump. In almost every case, the thermostat is located adjacent to the water pump and needs to be removed to access it. This saves you labor as you usually only would need to purchase the part during this job.

Table of Contents

How long does a water pump usually last? – Related Questions

What causes a water pump to fail?

Contaminated coolant, non-compatible coolant, or mixing coolants of different chemistries leads to premature water pump failure. Harmful contamination is common in systems that are not properly maintained. The coolant should be entirely replaced with the correct vehicle manufacturer’s recommended coolant.

Can you drive with a bad water pump?

The coolant is no longer circulating properly through the car. Heating and cooling may be affected by the vehicle. The car may begin to overheat as well. It is possible to drive your vehicle without a water pump, but not good to.

What happens when water pump goes out while driving?

If the water pump in your car fails, the motive force for the coolant quickly goes away allowing the water in the engine to heat up very quickly and your engine to overheat, possibly causing damage. If this happens to you, quickly pull over and shut down your engine.

What noise does a bad water pump make?

A whining or groaning noise usually means that either a drive belt is loose, or the water pump pulley is bad. It may surprise your customer that a pulley could fail. It does occasionally happen. Pulleys may fail due to rust, which can cause cracking between their bolt holes.

How hard is it to replace a water pump?

While removing the pump is not difficult, you must have experience removing and replacing timing belts and their various components. It takes just as much work to get down to the timing belt as it does the water pump, therefore you should plan on replacing the belt at the same time.

How long does it take to replace a water pump and thermostat?

The range is approximately two to three hours depending on whether your vehicle has power steering and/or air conditioning. It is economical to replace the pump on a mobile basis and you can obtain a repair quote for mobile replacement by referring to YourMechanic’s water pump replacement service page.

When replacing a water pump What else should you replace?

Check your owner’s manual for the proper interval to replace your timing belt and water pump or stop in and have one of our service experts review your car or truck’s maintenance needs with you one-on-one. Generally, the idler pulleys, tensioner and water pump should always be replaced when the timing belt is replaced.

See also  How do you increase turbo boost on a diesel?

Can you change the water pump without changing the timing belt?

Yes you can replace the water pump without replacing the serpentine belt. You will have to remove the belt to replace the water pump anyway. Since you are likely going to have to purchase a new pump, we do recommend that you purchase a belt at the same time.

How do you fix a water pump failure?

Solution: Replace the water pump. Thoroughly flush the cooling system before installing the new pump and refill the system with the correct vehicle manufacturer’s recommended coolant. Inspect the pressure cap and replace if defective.

How do you test a water pump on a car?

With the engine off, open your hood and locate the water pump pulley. With gloves on, grab it and wiggle it back and forth. There should be no movement, if there is, this along with the noise is a good indication you may have a water pump problem.

Will Stop Leak fix a water pump?

The liquid stop-leak product poured into the radiator will flow to the water pump seal and possibly seal or slow the leak. Stop-leak products are not a permanent solution and will only serve as a temporary fix.

Will a bad thermostat cause check engine light?

The most noticeable issues occur when the thermostat gets stuck in either the open or closed position. A malfunction can result in a trouble code, generated by the engine’s computer, which can turn on your check engine light.

Can I just replace the water pump gasket?

Can you replace a water pump gasket yourself? While the replacement of a bad water pump gasket itself can be done with basic hand tools, getting to it is the hard part. The bad water pump gasket may be in a very tight space under your hood, with several components in the way.

Will water pump leak if engine is off?

A large amount of coolant leaking from the water pump when the car is turned off can be caused by a failed water pump sealing gasket. This is the gasket between the water pump and the engine block.

Can a water pump be repaired?

Once the bearings fail inside the water pump, it means the unit cannot be repaired and will need to be replaced entirely. If you notice that there is a loud whining sound coming from the front of your motor that increases in volume as you accelerate, contact a mechanic as soon as possible to inspect your vehicle.

See also  What happens if car coolant freezes?

How long does it take to change a water pump and timing belt?

How long does a timing belt and water pump replacement take? The average time taken for a water pump and timing belt change is between 3 to 6 hours.

Is water pump covered under warranty?

Normal powertrain warranties cover the engine and all of it’s components. This typically covers everything in the engine block including the cylinder block and heads, the engine’s seals and gaskets (including the head gasket), the fuel injectors, and the water and oil pumps.

Should I replace water pump before it fails?

A modern car engine can survive mild overheating, but severe overheating can damage it. When does the water pump need to be replaced? The water pump doesn’t need to be changed in regular mileage intervals. It must be inspected during regular services and replaced if it’s bad or shows early signs of failing.

How much does it cost to change timing belt?

If your timing belt is in need of replacement, you can expect that service to cost anywhere from $300 up to $500. Because the timing belt is not easily reachable on many vehicles there is a good bit of disassembly and reassembly needed to get to the belt. Economy cars with smaller engines require less labor.

Will black pepper stop a water pump leak?

Will black pepper stop a water pump leak? Black pepper is used to close small radiator leaks. When black pepper is introduced into the system, the small particles move to the leak, where they expand and plug the leak. The pepper will not spoil and close the leak until you can have it repaired by a professional.

What happens if your water pump is leaking?

Rust or Deposit Build-Up

When the water pump has a small leak, there will be a gradual build-up of gunk or rust on the pump itself. Either way, your pump will become less efficient at moving coolant through the engine, eventually causing complete failure. Lifting your hood and checking over your engine is a good habit.

Leave a Comment